Drain Assembly - American Standard Passage A8011T-RHO Instrucciones De Instalación

1
Ensure that the floor and stud walls are square and plumb on a level floor as shown in Figure A. Provide a 5" x 5" (127 x127 mm)
opening in the floor for the drain and refer to the product rough-in for actual drain location. Draw a line 3-1/4" (82 mm) above the
level subfloor on the wall studs at each side of the opening.
2
All of the shower bases require purchasing a round shower strainer type drain for use with a standard 2" (51 mm) plastic
schedule 40 waste pipe. Figure B shows the typical drain assembly. Before installing drain into the shower base, remove
strainer. (Fig B) This will be installed after shower base is in its final position. Cut the waste pipe height so that the drain body
will fit snug in the shower base. Apply silicone sealant between the drain body and shower base.
NOTE: Drain not included and must be purchased separately.
MARK STUDS
ABOVE LEVEL SUBFLOOR
90°
2" (51 mm)
C/L
PVC Waste Pipe
(See Product Rough-In for Drain Location)
FIGURE A
FIGURE A

DRAIN ASSEMBLY

Rubber
Caulking
Gasket
Drain
Body
Silicone
Sealant
Rubber
Gasket
FIGURE B
FIGURE B
90°
Opening 6" x 6"
(152 x152 mm)
Strainer
Shower
Base
Fiber
Gasket
Locking
Nut
- 2 -
755467-100 Rev. 3 07/20