Uline SANITARE H-2665 Manual Del Usuario página 2

SERVICING OF DOUBLE-INSULATED APPLIANCES
A double-insulated appliance is marked with one or
more of the following: The words "DOUBLE INSULATION" or
"DOUBLE INSULATED" or the double insulation symbol
(square within a square).
In a double-insulated appliance, two systems of
insulation are provided instead of grounding. No
grounding means is provided on a double-insulated
appliance, nor should a means for grounding be
added to the appliance. Servicing a double-insulated
appliance requires extreme care and knowledge of the
system, and should be done only by qualified service
personnel. Replacement parts for a double insulated
appliance must be identical to the parts they replace.
CAUTION! Assemble the vacuum before using.
Moving parts, make sure ON/OFF switch is in
OFF (0) position before plugging in.
ATTACH HANDLE
CAUTION! Do not catch cord under handle.
1. From rear of vacuum, align handle with handle
groove and slide onto vacuum. If necessary, use
thumb and finger pressure to slide handle into
position. (See Figure 1)
2. Attach handle with the two 1" screws provided in the
assembly packet. Use a Phillips screwdriver.
(See Figure 1)
NOTE: Hand tighten with screwdriver to be sure
both screws are firmly seated.
Figure 1
Screws
PAGE 2 OF 30
SAFETY CONTINUED
Handle
Handle Groove
CAUTION! Do not oil the motor or the brush
roll. The motor and brush roll are permanently
sealed and lubricated.
THERMAL CUTOFF
This vacuum has a special thermostat that protects the
vacuum in case of motor overheating. If the vacuum
suddenly shuts off, push the ON/OFF switch OFF (0) and
unplug the vacuum. Check the vacuum for a possible
source of overheating such as a full dust cup, a blocked
hose or clogged filter. If these conditions are found, fix
them and wait at least 30 minutes before attempting to
use the vacuum. After the 30 minute period, plug the
vacuum back in and push the ON/OFF switch ON (l). If
the vacuum still does not run, then call for repair.
ASSEMBLY
ATTACH HOSE
1. Pick up hose and lay across upper hose retainer.
(See Figure 2)
2. Push the lower hose nozzle in the lower hose retainer
to secure. (See Figure 2)
ATTACH CORD
1. Attach extension cord to quick-change power cord.
Press cord into clip to secure the connection.
(See Figure 2)
Figure 2
Quick-Change
Power Cord
Clip
Extension
Cord
Upper Hose
Retainer
Upper Cord
Hook
Lower Hose
Nozzle
Lower Hose
Retainer
1020 IH-2665