Uline SANITARE H-2665 Manual Del Usuario página 5

4. Dump debris in a waste container. (See Figure 14)
Figure 14
HOW TO CLEAN OR CHANGE DUST CUP FILTER
1. Check and clean the filter frequently to maintain
good performance.
2. To remove debris, tap filter against waste container
and/or brush with dusting brush accessory tool. You
may also vacuum the filter using a different vacuum.
3. If filter needs further cleaning, wash in warm water
using a mild detergent. To clean between filter
pleats, fan open under running water.
4. If dust cup needs cleaning, wash in warm water
using a mild detergent. Do not submerge dust cup
lid, wipe only with a damp cloth.
5. When all parts are completely dry, replace filter in
dust cup and replace lid.
NOTE: These parts are not dishwasher safe.
NOTE: Dust cup filter may need to be replaced
if cleaning it does not restore cleaning
performance.
REINSTALLING THE DUST CUP
1. Replace filter onto center tube in dust cup applying
gentle pressure.
2. Line up the two tabs on dust cup with openings on lid,
rotate lid clockwise while applying pressure to secure.
The lock symbol (
cup handle when properly assembled. (See Figure 15)
Figure 15
3. To replace dust cup, position dust cup with handle
facing inside the dust cup compartment; place
bottom of dust cup in bottom of compartment and
rotate upward, pushing dust cup against vacuum
until it locks into place.
PAGE 5 OF 30
MAINTENANCE CONTINUED
) on lid will be centered over dust
Tab
Tab
HOW TO CLEAN PRE-MOTOR FILTER
1. Check the pre-motor filter each time the dust cup is
emptied. Clean or replace as needed. (See Figure 16)
Figure 16
Pre-Motor
Filter
2. Remove filter centered in the bottom of the dust cup
compartment.
3. Shake filter to remove excess dust. If necessary, the
filter can be cleaned by vacuuming with another
vacuum or washing with mild detergent.
4. Reinstall filter after completely dry.
HOW TO REMOVE HEPA CARTRIDGE FILTER
1. Check the HEPA filter each time dust cup is emptied.
Replace twice a year or as needed.
2. Push down on HEPA cartridge latch and remove filter.
(See Figure 17)
HOW TO CLEAN HEPA CARTRIDGE FILTER
1. Remove from vacuum.
2. To remove debris, tap filter against waste container
or brush off. You may also vacuum the filter using
a different vacuum. If filter needs further cleaning,
wash in warm water using a mild detergent. To clean
between filter pleats, fan open under running water.
NOTE: Do not put any parts in a dishwasher.
NOTE: Washable filter may need to be
replaced if cleaning it does not restore
cleaning performance.
NOTE: If filter is cleaned with water, be sure to let it
dry completely before re-installing.
HOW TO REPLACE HEPA CARTRIDGE FILTER
1. Place bottom tabs of filter cartridge into slots. Rotate
filter toward vacuum, press firmly against vacuum to
latch. Make sure HEPA cartridge latch is secured on
both sides.
HEPA
Cartridge
Filter
Figure 17
1020 IH-2665