Uline H-2624 Instrucciones

H-2624
3M H128 2" HEAVY
DUTY TAPE DISPENSER
SPECIFICATIONS
Tape Width: 2" (48 mm)
Tape Roll Diameter: Up to 5¾" (145 mm) maximum on a 3" (76.2 mm) diameter core
LOADING
1. Slide tape roll over flange. Dispense tape with
adhesive side facing down. Press down on roll to
fully mount on hub. (See Figure 1)
Figure 1
2. Thread end of tape through narrow guide slot. To
dispense the tape, hold the dispenser and pull the
leading edge of the tape from the roll. Allow the roll
to rotate freely on the dispenser. (See Figure 2)
Figure 2
Guide
Slot
OPERATING
1. Apply approximately 2" (48mm) of tape to the side
of the carton. (See Figure 3)
Figure 3
PAGE 1 OF 3
1-800-295-5510
uline.com
INSTRUCTIONS
Flange
2. Pull the dispenser across the carton seam, applying
pressure to the tape roll to obtain a tight seal.
3. Continue to tape approximately 2" (48mm) past the
end of the box, down the side panel.
4. To cut the tape, push down and rotate the dispenser
slightly. (See Figure 4)
REPLACING THE BLADE
WARNING! Use care when working near the
sharp blade.
1. Loosen, but do not remove the screws and nuts to
remove the blade.
2. Install the replacement blade with beveled cutting
edge pointing toward tape roll.
3. Seat blade on screws and center on blade clamp.
4. Tighten mounting screws and nuts to secure blade.
Para Español, vea página 2.
Pour le français, consulter la page 3.
Figure 4
1020 IH-2624