Troubleshooting; Error Checklist - Sennheiser SKP 500 G2 Manual De Instrucciones

All manuals and user guides at all-guides.com

Troubleshooting

Error checklist

Problem Possible cause
No Batteries are flat or
operation accupack is flat
indication
No RF signal Transmitter and
receiver are not on
the same channel
Transmitter is out of
range
RF signal Transmitter is muted
available, (MUTE)
no audio
Receiver's squelch
signal,
threshold is adjusted
"MUTE"
too high
display
Transmitter doesn't
appears on
transmit a
the display
pilot tone
panel
Audio signal Transmitter
has a high sensitivity is
level of adjusted too low
background
Receiver's AF output
noise
level is adjusted too
low
Audio signal Transmitter
is distorted sensitivity is
adjusted too high
Receiver's AF output
level is adjusted too
high
If problems occur that are not listed in the above table or if
the problems cannot be solved with the proposed solutions,
please contact your local Sennheiser agent for assistance.
24
Possible solution
Replace the
batteries or
recharge the
accupack
Set transmitter and
receiver to the same
channel
Check the squelch
threshold setting
or reduce the
distance between
transmitter and
receiving antenna
Deactivate the
muting function
Reduce the squelch
threshold
Activate the pilot
tone transmission
See "Adjusting the
sensitivity" on
page 20
Increase the audio
output level
See "Adjusting the
sensitivity" on
page 20
Reduce the AF
output level