EAS ELECTRIC EMH46VOLCAN Manual página 40

Cleaning and Maintenance
■ Remove the burner lids and Flame Spreaders by pulling them upwards and away
from the top plate.
■ Soak them in hot water and a little detergent or washing up liqui.
■ After cleaning and washing them, wipe and dry them carefully. Make sure that the
flame holes are clean and completely dry.
■ Wipe the fixed parts of the burner cup with a damp cloth and dry afterwards.
■ Gently wipe the ignition device and flame supervision device with a well wrung-out
cloth and wipe dry with a clean cloth.
■ Before placing the burners back on the top plate, make sure that the injector is not
blocked.
For the Triple-Crown burners:
1. . Place the circle burner cap(2) and burner lid(1) on the flame spreader(3) in tu
2. . Place the flame spreader(5) onto the burner cup(6) and place the burner lid(4) on
the flame spreader(5).
3.Position the flame spreader(3) onto the burner lid(4).
For the Auxiliary,Semi-rapid and Rapid:
1. Place the flame spreader (8) onto the burner cup(9) so that the ignition device and the
flame supervision device extend through their respective holes in the flame spreader.
2. Position the burner lid(7) onto the flame spreader(8) ,so that the retaining pins fit into
their respective recesses.
1
2
7
3
4
8
5
9
6
EN-14 V.2