Installing The Appliance - EAS ELECTRIC EMH46VOLCAN Manual

Installing the appliance

Bottom view
(A) SEALING STRIP
(C) SCREW
Remove the pan supports, the burner lid
1.
and flame spreader and carefully turn the
appliance upside down and place it on a
cushioned mat.
Take care that the Ignition devices and
flame supervision devices are not damaged
in this operation.
2. Apply the sponge provided around the
edge of the appliance.
3.
Do not leave a gap in the sealing agent or
overlap the thickness.
1. Place the bracket (B) over the holes that match the size
of the screws.There are one set of screw holes in
each corner of the hob (H) .
Slightly tighten a screw (C) through the bracket (B) so
that the bracket is attached to the hob, but so that you
can still adjust the position .
. 2 Carefully turn the hob back over and then gently lower
it into the aperture hole that you have cut out.
. 3 On the underneath of the hob, adjust the brackets into
a position that is suitable for your worktop.
Then fully tighten the screws (C) to secure the hob
(B) BRACKET
into position.
Sponge
The thickness of the sponge is 3 mm.
The width of the sponge is 10 mm.
Do not use a silicon sealant to seal the
appliance against the aperture.
EN-17 V.2