ShenPaz Focus 4010 Manual De Instrucciones página 17

4.3 Canceling a Cycle
Should you wish to cancel the program in the middle of a firing cycle, press the
[STOP/LIFT] key? The platform is lowered and the furnace remains in the selected
program mode.
5. Supplementary Features
5.1 Countdown Time to the End of the Cycle
You can see the Time left to the end of the cycle in the middle high section of the
screen, while sending the program but also in the screen mode
5.2 The Hold Key
The HOLD/RELEASE function is available only during a cycle. The [HOLD] key when
pressed will temporarily "freeze" the firing cycle. The temperature is held (in case the
HOLD key was pressed during the Heating) and the platform stops moving (in case the
HOLD key was pressed during the UP TIME).
When HOLD key is pressed, the color of "Cycle" change to orange. During the HOLD stage
a single-tone single beep is heard repeatedly to remind the user that the furnace is still in
the HOLD stage. To release the furnace from the HOLD stage, press HOLD. The indications
of the HOLD stage will disappear and the furnace will return to normal operation.
During this "freezing stage", you can manually control and extend the drying time, cooling
time, and glazing time,
extended, Press the [HOLD] key, this will release the furnace from the "HOLD"
stage, and the furnace will return to the firing cycle
This function provides the user with the flexibility to have an elective and full control
over the work being in cycle. It enables the control of drying, heating and the cooling
stages.
FOCUS 4010/HT Dental Porcelain Furnace
When you decide that the time has been sufficiently
.
Page 17 Manual version 20.08.2015