ShenPaz Focus 4010 Manual De Instrucciones página 19

5.5 The STOP/LIFT Key
The [STOP/LIFT] key serves for cycle canceling.
A short press of the [STOP/LIFT] key, will lower the platform
If you wish to cancel a program in the middle of a firing cycle, press the [STOP/LIFT]
key. The platform is lowered and the furnace remains in the selected program mode
5.6 The High Temperature version
Focus 4010 HT
The furnace have specific feature adapted to high temperature firing, Cycling at up to
1180 degrees and up to 4:30 Hours,
This product is adapt for all kind of alumina product sintering with and without vacuum
for all delay request in resolution of -from 1 minutes up to 4:30 hours.
In high temp utilization on long cycles it's recommended to exchange the table without O
ring, for short cycle up to 30 minutes
All the programs can be modified and adapted to all kind of manufacturer requests.
The Focus Ht is one of the only furnaces that allow you to sintering Alumina as also to
fire the conventional ceramic in the same furnace.
In programs 201-250 the time presentation is in Hours HH:MM
In normal programs 1-199 the time presentation is in minutes and seconds MM:SS
HT Program: from 201 up to 249 incl. 100 °C – 1180 °C
Normal Program: from prog 1 to 200 100 °C –1150 C
5.7 Manual Pre-Heating/Drying
User can manually raise the platforms to any height in order to heat up an object or in
case additional pre-heating is required. In order to perform it, you should choose the
program number (PROG# - ENT) with START TEMP you will need to receive the optimal
preheating.


FOCUS 4010/HT Dental Porcelain Furnace
Press the UP arrow continuously and the platform
will start to rise. Move the platform by pressing the
UP arrow until the required distance between the
object and the opening of the muffle is achieved.
In order to lower the platform - use the DOWN arrow continuously.
Page 19 Manual version 20.08.2015