Russell Hobbs 20355-56 Instrucciones página 4

C RAISING THE ARM
1 The springs in the arm are quite powerful, so:
a) Check that the appliance is switched off (0)
b) Hold the bottom of the appliance.
c) Keep clear of the top of the arm.
d) Turn the arm release to U.
e) The arm will move to the raised position.
f) Let go.
C THE BOWL
2 Raise the arm before fitting or removing the bowl.
3 Fit the bowl to the appliance and turn it clockwise.
4 Turn it anti-clockwise to release it.
5 The contents of the bowl will rise when you start the motor – the higher the speed, the more
they'll rise.
6 Try not to fill the bowl more than about half full (specially when using the whisk).
, Use only the bowl supplied.
C THE ATTACHMENTS
7 Fit and remove the attachments with the appliance switched off and unplugged, and the arm
raised.
8 Align the slot in the top of the attachment with the lug on the drive shaft, push the
attachment on to the drive shaft, and turn it anti-clockwise.
9 To remove an attachment, push it on to the drive shaft, turn it clockwise, then pull it off.
C LOWER THE ARM
a) Check that the appliance is switched off (0).
b) Hold the bottom of the appliance.
c) Turn the arm release to U.
d) Press the arm down.
e) Let the arm release go.
f) Let go.
C THE SPLASH GUARD
10 The splash guard fits on top of the bowl.
11 The funnel lets you add ingredients without removing the splash guard.
12 With the bowl in position, and the arm down:
a) slide the splash guard between the arm and the bowl
b) Turn the splash guard towards you, so that you can add ingredients easily.
c) Align the tabs on the sides of the funnel with the grooves in the open part of the splash
guard.
d) Slide the funnel down to cover the open part of the splash guard.
13 To remove the splash guard:
e) Lift the funnel off.
f) Lift the splash guard slightly, to clear the bowl rim.
g) Pull it out from between the bowl and the arm.
C SWITCH ON
14 Sit the motor unit on a dry, firm, level surface, near a power socket.
15 Check that the speed control is set to 0.
16 Put the plug into the power socket.
4