Step 4 - Attach Exhaust Hose To The Exhaust Nozzle; Step 5 - Connect Exhaust Hose To The Air Conditioner - Haier HPP08XCR Instrucciones De Instalación Y Manual Del Usuario

NOTE: There are many window types on the market
today. Use the foam strips and brackets (provided)
to secure the extension panels that fill the window
opening.
4. Place the two top window brackets and two bottom
window brackets where they will best support the
extension panels.
Before Assembly
a
b
A Top Window Brackets
B Bottom Window Brackets
After Assembly
5. Apply the top foam strip (provided) across the top of the
window panel assembly, and then apply the bottom
foam strip (provided) across the bottom front edge of
the window panel assembly, as shown.
a
b
c
d
A Top Foam Strip
B Top Bracket
C Extension Panel
6. Place the window panel assembly in the window, and
using the screws provided, fasten the assembly to the
window sill and window frame.
a
b
e
D Bottom Bracket
E Bottom Foam Strip
7. Using one pointed screw, install the Security bracket to
the window.
NOTE: The security bracket prevents the window
from being opened from the outside.
a
b
STEP 4 - ATTACH EXHAUST HOSE
TO THE EXHAUST NOZZLE
1. Grasp both ends of the exhaust hose and gently pull to
expand the hose.
NOTE: Do not attach additional hoses to extend the
length. This would decrease cooling efficiency and
may damage the air conditioner.
2. Using a counterclockwise motion, attach the open end
of the exhaust hose to the exhaust nozzle.
a
b
c
STEP 5 - CONNECT EXHAUST HOSE
TO THE AIR CONDITIONER
IMPORTANT: When connecting the hose, the air
conditioner must be close enough to the window that
you will not dislodge the window seal plate. Once the
hose is connected, move the air conditioner 20" (51 cm)
from the wall.
1. Align the notches on the connector end of the exhaust
hose with the ridges in the opening on the back of the
air conditioner.
6
A Security Bracket
B Pointed Screw (1)
A Exhaust Nozzle
B Hose (open end)
C Hose (connector
end)