Remote Control; Indicator Lights - Haier HPP08XCR Instrucciones De Instalación Y Manual Del Usuario

•
Press the Fan Speed button to toggle among the two
speeds. The corresponding fan speed indicator will
illuminate.
C REMOTE CONTROL SIGNAL RECEIVING WINDOW
Aim the Remote Control at this window so the Control
will receive the signal.
D CONTROL PANEL DISPLAY
Displays the Set Temperature in degrees Fahrenheit or
degrees Celsius, or the hours remaining in a Time Delay.
The corresponding indicator light will illuminate.
E UP AND DOWN ARROW BUTTONS
Adjusts the Temperature or Hours in Time Delay.
To Set the Temperature:
The temperature can be set between 62ºF and 86º F
(17ºC and 30º C) when the air conditioner is in Cool
mode.
1. Press the Mode button until the Cool mode is
selected.
2. Press the Up Arrow or Down Arrow buttons to
select the Temperature.
NOTE: The temperature cannot be set when
the air conditioner is in either Fan or Dry mode.
F MODE BUTTON
Press the Mode button to toggle among the three
operating modes. The corresponding indicator will
illuminate:
Cool – Cools the room to the set temperature
Dehum – Reduces the humidity in the room
Fan – Circulates the air in the room without cooling
G POWER BUTTON
Turns ON/OFF power to the air conditioner.
NOTE: Turning off power by pressing the Power
button does NOT disconnect the appliance from the
power supply.
•
Press the Power button. The Power indicator will
illuminate.

REMOTE CONTROL

a
1. Insert the two batteries (provided).
2. Aim the remote control at the signal receiver on the
control panel to operate the air conditioner.
A SLEEP BUTTON
Increases the set temperature by 2ºF (1ºC) after 2-
hours, and then increases the temperature by an
additional 2ºF (1ºC) after another 2-hours.
NOTE: The fan will operate at Low speed and cannot
be adjusted while in Sleep mode.
Press the Sleep button to enter Sleep mode. The Sleep
indicator will illuminate.
To Cancel Sleep Mode:
•
Press the Sleep button or any of the Mode buttons
(Cool, Fan or Dry) on the remote control.
B °C/°F BUTTON
•
Press the °C/°F button to toggle between displaying
the temperature in degrees Fahrenheit or degrees
Celsius. The corresponding indicator will illuminate.

INDICATOR LIGHTS

Timer High Low Water Full Cool
a
Illuminate to indicate the selected mode, speed or
condition.
A WATER FULL
The Water Full indicator illuminates, when the internal
water tank has filled with condensed water. The air
conditioner will turn off automatically. To drain the water
tank, see "Air Conditioner Care" for instructions.
8
High Cool
Low TEMP Dehum
Sleep Fan
b
C / F
TIMER POWER
Fan Dehum Sleep POWER