Overview; Start Up - Würth SEG 10-2 Manual De Instrucciones

Overview

Quick start instructions
Illustration
1 Connect spray/suction hose to the elbow,
Connect spray/suction hose to the appliance
2 Prepare cleaning solution,
Fill up the fresh water tank
3 Select operating mode
4 Cleaning
5 Empty the fresh water tank
6 Empty wastewater container
7 Fill fresh water tank (without detergent),
Flush appliance
8 Clean lint trap,
Clean fresh water sieve
9 Allow appliance to dry
Device elements
Illustration
1 Manual nozzle for upholstery cleaning
2 Hook for spray/suction hose
3 Holder for accessories
4 Power cord
5 Quick start instructions
6 Switch for spraying
7 Switch for vacuuming
8 Fresh water sieve
9 Casing
10 Nameplate
11 Steering roller
12 Spray hose connection
13 Suction hose connection
14 Nozzle mouth piece
15 Union joint
16 Cover
17 Fresh water tank
18 Carrying handle of the appliance
19 Bender
20 Lever on the manifold
21 Spray hose
22 Suction hose
23 Spray/suction hose
24 Dirt water reservoir, detachable
25 Carrying handle of the wastewater container
26 Seal on the lid
27 Fluff filter

Start up

 Check high power cable, extension cables
and hoses for damage every time before use.
Attaching the Accessories
 Attach the elbow to the hand nozzle and
hand-tighten the union nut on the elbow.
 Insert the suction hose into the suction hose
connection on the appliance.
Attach the coupling of the spray hose to the
spray hose connection of the appliance and
snap in place.
 Connect the suction hose to the elbow.
Connect the coupling of the spray hose with
the manifold and snap in place.
Prepare cleaning solution
DANGER
Health risk, risk of damage. Observe all
indications on the detergent used.
 Mix fresh water and detergent in a clean con-
tainer (use the concentration recommended
for the detergent).
Dissolve detergent in the water.
Note: Warm water (max. 50°C) will increase the
cleaning effect. Verify the temperature resistance
of the surface to be cleaned.
Note: For considerate treatment of the environ-
ment use detergent economically.
Fill up fresh water reservoir
 Fill detergent solution into the fresh water res-
ervoir. The fill level must not exceed the "MAX"
mark.
Defoaming agent
Note: When cleaning previously shampooed car-
pets, foam is generated in the wastewater contain-
er. This formation of foam can be prevented by
adding a defoaming agent.
GB - 2 13