Operation - Würth SEG 10-2 Manual De Instrucciones

Operation

Turning on the Appliance
 Plug in the mains plug.
 Press the suction switch to turn on the suction
turbine.
 Press the spray switch to switch on the spray
pump.
Cleaning
ATTENTION
Risk of damage. Check the object to be
cleaned prior to using the appliance in
an inconspicuous place for colour fast-
ness and water resistance.
 Operate the lever on the manifold in order to
spray the cleaning solution.
 Run across the surface to be cleaned in over-
lapping paths. Pull the nozzle backwards (do
not push).
 When changing nozzles, the hand nozzle can
be put into the accessories holder.
Turn off the appliance
 Switch off the spray and suction switches.
 Pull out the mains plug.
Empty wastewater container
 If the dirt water reservoir is full, switch off the
suction and spray switches.
 Remove the lid.
 Remove the wastewater container from the ap-
pliance and drain it.
Empty the fresh water reservoir
 Turn off the appliance.
 Shortly activate the lever on bender to de-
crease the pressure.
 Separate bender from the spray/suction hose.
 Insert the suction hose into the fresh water res-
ervoir.
 Press the suction switch to turn on the suction
turbine.
14
 Empty the fresh water reservoir and switch the
appliance off.
 Remove the lid.
 Remove the wastewater container from the ap-
pliance and drain it.
Flush appliance
 Connect the elbow (with hand nozzle) to the
suction hose.
 Connect the coupling of the spray hose with
the manifold and snap in place.
 Fill approx. 2 litres of fresh water into the fresh
water reservoir.
Do not add any detergents.
 Press the spray switch to switch on the spray
pump.
 Hold hand nozzle over a drain.
 Activate lever on bender and flush the appli-
ance for appr. 1 to 2 minutes.
 Turn off the appliance.
After each operation
 Flush appliance.
 Empty the wastewater container and clean it
under running water.
 Empty the fresh water reservoir.
 Clean the outside of the appliance with a
damp cloth.
 Remove all water from the appliance prior to
longer periods of non-use to avoid offensive
odours.
 Allow appliance to dry thoroughly: Remove or
move lid sideways.
Storing the Appliance
Illustration
 Coil the power cable around the carrying han-
dle and the lid of the appliance.
 Place the appliance in a dry room and secure
it from unauthorized use.
GB - 3