Cleaning Methods; Transport; Storage; Care And Maintenance - Würth SEG 10-2 Manual De Instrucciones

Cleaning methods

Normal soiling
 Spray and suction off detergent solution in one
work cycle.
Note: Repeated suctioning without spraying will
shorten the drying time.
Strong soiling or stains
 Apply detergent solution with suction turbine
turned off and soak for 10 to 15 minutes.
 Clean the surface just like with normal soiling.
 In order to further improve the cleaning result,
the surface can be recleaned using clear,
warm water.
Upholstery cleaning
 With sensitive materials, use less detergent
and spray the surface at a distance of approx.
200 mm. Then simply vacuum off.
Cleaning tips
Highly soiled spots should be presoaked and
–
the detergent solution should soak 5 to 10 min-
utes.
Always work from the light to the shade (from
–
the window to the door).
Always work from the cleaned to the un-
–
cleaned surface.
The more sensitive the surface (oriental rugs,
–
berbers, upholstery material) the lower the
cleaning solution concentration should be.
Rugs with jute backing can shrink if too much
–
water is used and can bleed colours.
Brush high-fiber rugs in the direction of the
–
weave after cleaning (using a fiber brush or a
scrubber).
Impregnating after wet cleaning prevents the
–
textile from being quickly soiled again.
Do not step on cleaned surfaces until they
–
have dried and do not place furniture on them
to avoid pressure spots or rust stains.
Detergent
Carpet and upholstery clean-
ing
For further information, please request product in-
formation sheet and EU safety data sheet of the rel-
evant detergent.

Transport

CAUTION
Risk of injury and damage! Observe the
weight of the appliance when you trans-
port it.
Illustration
 Insert the spray/suction hose into the hook.
 When transporting in vehicles, secure the ap-
pliance according to the guidelines from slip-
ping and tipping over.

Storage

CAUTION
Risk of injury and damage! Note the
weight of the appliance in case of stor-
age.
This appliance must only be stored in interior
rooms.

Care and maintenance

DANGER
Danger of injury by electric shock.
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
ATTENTION
Keep the device and the ventilation lou-
vres clean in order to be able to work
well and safely.
Should the spray retraction device fail in spite
–
of our thorough manufacturing and testing
procedures, have the repair performed by a
Würth Master Service.
For all queries and spare part orders, always
–
state the item number according to the spray
retraction device's type plate.
GB - 4
R1 cleaner
BMF cleaner
15