Waeco MagicTouch MT100 Instrucciones De Montaje Y De Uso página 26

_IA_MT100.book Seite 24 Freitag, 28. Mai 2010 9:04 21
Connecting MT100
8.2 Connecting MT100 to the central locking system
Supplementary to fig. 6
➤
Connect MagicTouch in accordance with the corresponding circuit diagram (for
details, see table „Keys for the circuit diagrams" auf Seite 24):
Vehicles without a servo motor in the driver's door (driver's door cannot be
locked and unlocked from the passenger's door) or with pressure vacuum
central locking without electrical control cable: fig. 7
In these cases, you will require an additional servo motor, WAECO type no.
ML-11 for the driver's door.
Two cables switching from negative to +12 V: fig. 8
Two +12 V pulse control cables: fig. 9
Two negative pulse control cables: fig. 0
One open and negative pulse control cable: fig. a
One +12 V and negative pulse control cable: fig. b
Connection to the WAECO central locking system ML-44(22): fig. c
NOTE
I
Check whether the indicators flash once upon locking with the remote
control.
If they flash twice, you will need to reconnect the grey/yellow cable to pin 12
and the blue/yellow cable to pin 13 of the control unit.
Keys for the circuit diagrams
No. in fig. 7
Designation
to fig. c
1 Control unit for the vehicle's own central locking system
2 Control switch (driver's door) for the original central locking
system, central locking closed
3 Control switch (driver's door) for the original central locking
system, central locking open
NOTE
I
Pull the plug out before disconnecting the cable bridge.
There is a cable bridge on the plug of the cable set between pin 7 and
pin 11:
Cable bridge closed (factory setting): for electric servo motors (activation
time: 0.7 s)
Cable bridge open: for pneumatic servo motors (activation time: 3 s)
24
MagicTouch MT100