Waeco MagicTouch MT100 Instrucciones De Montaje Y De Uso página 36

Ocultar thumbs Ver también para MagicTouch MT100:
Tabla de contenido

Publicidad

_IA_MT100.book Seite 34 Freitag, 28. Mai 2010 9:04 21
Operating MagicTouch
Never attempt to do the following with batteries:
– recharge them,
– open them or
– throw them in fires.
To replace the batteries, proceed as follows:
Use a screwdriver to open the housing.
Replace the battery (1).
Make sure that the polarity is correct when you insert the battery (battery type
CR 2032 3 V). The positive terminal is at the top.
Batteries are available e. g. at photo shops, watchmakers, etc.
Press both halves of the housing back together.
9.3
Learning or deprogramming the hand-held transmitter
See fig. f
MagicTouch can be operated using up to 10 hand-held transmitters. If a new hand-
held transmitter is to be learned, all other transmitters will have to be paired again.
Proceed as follows for learning a new hand-held transmitter:
To switch to learning mode:
Use a hand-held transmitter to open the vehicle.
Take a seat in the vehicle and leave the door open.
Switch on the ignition.
Press and hold the "Learn" button on a hand-held transmitter already paired.
Switch the ignition off.
Let go of the button.
The hazard lights flash 10 times and then remain lit.
The system is now in learning mode.
NOTE
I
If you do not press a button within 10 seconds, you will exit the learning
mode.
Learning the hand-held transmitter
Learn all the hand-held transmitters which you would like to use during this learning
phase. This also applies for the hand-held transmitters which you have already been
using!
Press the "Learn" button on the hand-held transmitter.
The hazard lights turn off while the value is being saved.
If the hazard lights light up again after 2 seconds and remain lit, then the hand-
held receiver has been learned and you can now proceed with the next one.
34
MagicTouch MT100

Publicidad

Tabla de contenido
loading

Tabla de contenido