Rocker Lock; Electrical Connection; Electrical Safety Instructions - Scheppach wox d 700 Manual De Instrucciones

GB

Rocker lock

• To transport the rocker circular saw lock in place the rocker
lock in position (1).
1

Electrical connection

• Connect the machine with a CEE-plug to the power supply, provided supply should be 16 .
• Switch on the machine with the power switch, the saw shaft runs up.
• Upon switching off the saw shaft is slowed down within 10 seconds.
Changing of rolling direction
The installed electrical motor is connected ready to operate. The connection complies with the relevant VDE and DIN-regulations.
The power supplied by the customer as well as the used extension cable should comply with these regulations resp. the
local regulations.
Motor-brake appliance
The brake slowes down the motor of the saw shaft within 10 seconds. The electrical braking is interrupted after maximum 14 sec-
onds. (wox d700)
In case the braking takes more than 10 seconds the machine should not be used again, as the brake is defective. The machine
implicitly needs to be disconnected from the power supply. Only an electronic specialist should be instructed to repair this malfunc-
tion.
The electrical motor is dimensioned for operating mode S 6 - 40 %.
S6 = pass operation with load exposure
40% = related to 10 min. 4min. load; 6min. pass operation
If the motor gets overcharged, it automatically switches off, as a winding thermal switch is built in in the winding of the motor. After
a cool-down period (time varies) the motor can be switched on again.
Seite:76