Scheppach wox d 700 Manual De Instrucciones página 77

m
Defective electrical power supply cords
Electrical power supply cords often suffer insulation damages.
Possible causes:
• Pressure spots, when power supply cords are being led through windows or doors.
• Buckling spots by incorrect attachment or guidance of the power supply cords.
• Cuttings by driving over a power supply cord.
• Insulation damages through pulling out of the socket.
• Cracks in worn-out insulation.
m
Such defective electrical power suplly cords should not be used and are extremely dangerous because of the insulation damage.
Check electrical power supply cords on damages on a regular base. Please pay attention that upon checking the power supply cord
is not plugged in. Electrical power supply cords have to comply with the relevant VDE and DIN-regulations. Only use power cables
with the qualification H 07 RN. The type denomination should be imprinted.
There has to be an imprint of the type denomination on the connection cable.
• Extension cables must be up to 25 m long, have a cross cut of 1.5 square millimeter, be over 25 m length, and have a minimum
2.5 square millimeter.
• The powersupply should be 16 A.
Rotary current motor
• The power supply has to be 380-420 Volt / 50 Hz.
• The power supply and the extension cables must be 5-fold leads = 3 P + N + SL.
• Extension cables must have a minimum cable cross section of 1.5 square millimeter.
• The power supply should be maximum 16 A.
• In case of connection to the power supply or moving site the rotary direction should be checked, otherwise the polarity has to be
changed.
Alternating current motor
• The supply voltage hast to be 220-240 Volt / 50 Hz.
• Extension cables must be up to 25 m long, have a cross cut of 1.5 square millimeter, be over 25 m long, and have a minimum 2.5
millimeter.
• The power supply should be 16 A.
m
Connections and repairs of the electrical equipment should only be carried out by an electrical specialist.
In case you have further questions, please specify the following:
• Motor manufacturer
• Current type of the motor
• Information of the machine type label
• Information of the switch type label
If you send the motor back, always return the complete power unit with electro-control.
GB
Seite:77