Promise Technology VTRAK J610s Guia De Inicio Rapido página 7

3. Attach the mounting rail assemblies to the outside of the rack posts, using
the attaching screws from your rack system.
Be sure the support is on the bottom facing inward.
4. Square the rail assemblies in the rack.
5. Tighten the adjustment screws and the attaching screws.
6. Place the VTrak subsystem onto the rails.
7. Secure the VTrak subsystem to the rack through each handle, using the
attaching screws from your rack system.
Figure 6. Rack mount assembly diagram
Rack front post
Rail adjustment screw
Inside of post
Rail attaching screw
(not included)
Front rail
Step 2: Mounting VTrak Unit in a Rack
Rail attaching screw
(not included)
Rear rail
Flange
Support
Rail adjustment screw
7
Rack back post
Inside of post