Gorenje Tiki TC 200-300/B Instrucciones De Uso página 45

TČ 200-1/Z-S
A 1150
B 560
C 380
D -
E -
F 1010
G 960
*
H* 1550
HV G 1
IM G 1
CV G 3/4
VM G 1
TV G 1
HP
side
On the rear side of the hot water tank there are special channels (H1, H2) for mounting the feelers for regulation
of the system connection of the hot water tank to other heating sources. Access to the channels is under the
covering joint of the protective covering, approximately in the middle of the tank height.
Insert the feeler into the channel. Recommended position (h1, h2) of the feeler is marked on the drawing:
- If the feeler is mounted higher than recommended, the thermostat will react too fast, the operating time of the
circular pump will be shorter and the difference between the temperature in the hot water tank and heating
media after the thermostat switch off will be higher. This means that the quantity of water in the hot water tank
and its temperature will be lower,
- If the feeler is mounted lower than recommended, the operating time of the circular pump will be longer and
the difference between the temperature in the hot water tank and heating media after the thermostat switch
off will be lower. This means that the quantity of water in the hot water tank and its temperature will be little
higher.
TČ 300 -1/ Z-S TČ 300-2/Z,S
1550 1550
740 740
560 560
- 930
- 360
1410 1410
960 960
1950 1950
G 1 G 1
G 1 G 1
G 3/4 G 3/4
G 1 G 1
G 1 G 1
Technical characteristics of the heating pump
Refrigerating agent
Connected power
Heating power
Voltage
Heating number
Adjusted water temperature
Legionella control programme
Operation zone - air
HV - Cold water inflow (blue rosette)
IM - HE medium outlet (blue rosette)
CV - Circulation conduit (blue rosette)
VM - HE medium inflow (red rosette)
TV - Cold water outflow (red rosette)
HP
top
R 134a
600 W
1850 W
230 V / 50 Hz
to 3.3
55°C
65°C
7°C to 35°C
45