Denon AVR-770SD Instrucciones De Operación página 8

ENGLISH
Connecting a Video Component Equipped with Color Difference (Component -
Y, P /C , P /C ) Video Jacks (DVD Player)
R R B B
• When making connections, also refer to the operating instructions of the other components.
• The signals input to the color difference (component) video jacks are not output from the VIDEO output jack
(yellow) or the S-Video output jack. In addition, the video signals input to the VIDEO input (yellow) and S-Video
input jacks are not output to the color difference (component) video jacks.
• Some video sources with component video outputs are labeled Y, C
terms all refer to component video color difference output.
• At SYSTEM SETUP, the component video input terminal can be assigned for the input sources to which you
want to connect AV devices. (For details, see page 15.)
DVD player
COMPONENT
VIDEO OUT
B
Y C C
B R
Monitor TV
COMPONENT
VIDEO IN
Y C C
B R
• The color difference input jacks may be indicated differently on
some TVs, monitors or video components ("C
B-Y and Y", "Pr, Pb and Y", etc.). For details, carefully read the
operating instructions included with the TV or other component.
• Video Conversion signals
Signal input to the AVR-770SD Video signal output to VIDEO
MONITOR OUT jack (yellow)
C
Video signal input jack
C
S-Video signal input jack
(Down-conversion)
Color difference (component)
E
Video signal input jack
8
B , C R , or Y, Pb, Pr, or Y, R-Y, B-Y. These
Connecting a DVD player
DVD IN jacks
• Connect the DVD player's color difference (component) video output jacks
(COMPONENT VIDEO OUTPUT) to the COMPONENT DVD IN jack using
75 Ω/ohms coaxial video pin-plug cords.
• In the same way, another video source with component video outputs
such as a TV/DBS tuner, etc., can be connected to the TV/DBS color
difference (component) video jacks.
Connecting a monitor TV
MONITOR OUT jack
• Connect the TV's color difference (component) video input jacks
(COMPONENT VIDEO INPUT) to the COMPONENT MONITOR
OUT jack using 75 Ω/ohms coaxial video pin-plug cords.
, C and Y", "R-Y,
R B
Monitor Output jacks
Video signal output to color
Video signal output to S-Video
difference (component) Video
MONITOR OUT jack
MONITOR OUT jack
C
(Up-conversion)
C
E
(C : Video signal output, E : Video signal not output)
Connecting the antenna terminals
DIRECTION OF
BROADCASTING
FM ANTENNA
STATION
75 Ω/ohms
COAXIAL
CABLE
FM ANTENNA
ADAPTER
FM INDOOR
ANTENNA
(An accessory)
AM loop antenna assembly
1 2
Remove the vinyl tie
and take out the
connection line.
4
a. With the
antenna on top
any stable
surface.
Mount
b. With the antenna
attached to a
wall.
Installation hole Mount on wall, etc.
E
E
C
FEEDER
CABLE
GROUND
Connection of AM antennas
Connect to the AM
1. Push the lever. 2. Insert the
antenna terminals.
3
Bend in the reverse
direction.
NOTES:
• Do not connect two FM antennas simultaneously.
• Even if an external AM antenna is used, do not
disconnect the AM loop antenna.
• Make sure AM loop antenna lead terminals do
not touch metal parts of the panel.
AM LOOP
ANTENNA
(An Accessory)
AM OUTDOOR
ANTENNA
3. Return the
conductor. lever.