Pre-Installation - K2 Pumps UTS03301K Manual Del Propietário

may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.
20. This pump does not require a connection to a main stack vent, per the National Standard Plumbing Code (NSPC)
2003 Section 11.7.9.

PRE-INSTALLATION

APPLICATION
This pump is designed to be used with a sink where a gravity drain line is not available. Attach the pump to the drain tail
piece; the pump will start when water begins to drain. Uses include basement laundry sinks, wet bars and utility sinks.
TOOLS REQUIRED
Flathead
Screwdriver
SPECIFICATIONS
Power supply
Liquid temp. range
Pump Inlet
Pump discharge
For Professional Technical Support call 1-844-242-2475
Phillips
Screwdriver
Hacksaw
115V, 60 HZ., 15 Amp Circuit
32 to 95° F (0- 35° C)
1-1/2 in. NPT
1-1/4 in. NPT
Channel
Locks
Safety
goggles
Pipe wrench
Tape
Measure
3