LG RESU16H Prime Manual De Instalación página 8

Ocultar thumbs Ver también para RESU16H Prime:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Standing bracket 1
Standing bracket_1
Battery Module B
n t
F r o
R e a
r
Label
Wall
Battery Module Direction
R e a
n t
r
F r o
Battery Module A
Spacer
(used for assmbly ang disassembly)
F r o
n t
F r o
Label
Wall
Battery Module B
Rear
Front
Battery Module A
F r o
F r o
TOP VIEW
n t
n t
F r o
n t
F r o
n t
Module Support BRKT
8
3. Remove the Drill template. Then pre-
tighten the fasteners on the Standing
Bracket 1.
* The fasteners will be fully tightened
in a later step.
4. Place Battery Module B on the rear
side of Module Connect plate.
* The side without bolts is the front
of the Battery Module.
* Check the label to confi rm the
battery pack is of B. Label is
attached on the left side of Battery
Module.
5. Place Battery Module A on the front
side of Module Connect plate. The
Rear side of each Battery Module
should face each other. After that,
TOP
remove the Spacer between the wall
and Battery Module.
* Check the label to confi rm the
Battery pack is of A. Label is
n t
attached on the left side of Battery
Module.
F r o
n t
6. Assemble Module Support BRKTs
using 6 bolts each.
* Tighten the M6 Flange Bolts (x12)
with a torque of 5N·m.
Spacer
(used for assmbly ang disassembly)
Spacer
TOP VIEW
Battery Control Unit
Battery Control Unit
Battery Control Unit
n t
F r o
n t
F r o
Sensing connector
Power connector
Sensing connector
Power connector
"Click!"
7. Remove bubble wrap from
Battery Control Unit
connectors of Battery Control Unit
and the warning label of Battery
Modules.
Battery Modules
8. Place the spacers on the position
Spacer
marked with label on Battery
Modules.
TOP
9. Place the Battery Control Unit on
top of the spacers, and align with the
Battery Module.
* Be careful not to break the
connector between the spacers and
the Battery Control Unit.
10. Connect the power and sensor
connectors on the right and left sides
(2 each). Assemble the connectors
until you hear a "Click". After that,
lock the power connector by pressing
F r o
F r o
n t
n t
TPA (Terminal Position Assurance).
TPA
TPA

Publicidad

Tabla de contenido
loading

Tabla de contenido