Axis Q60-E Serie Guia De Instalacion página 17

1
Network connector – RJ45 Push-pull Connector (IP66)
2
Network connector and network connector shield
3
Ground screw T20
4
Washer
5
Cable shoe
5. Attach the grounding wire (torque 1.5 to 2 Nm) to the cable shoe using cable shoe pliers.
6. Put the cable shoe and washer back in their original positions and tighten the screw
(torque 0.5 Nm). Make sure the cable shoe is in contact with the grounding surface.
NO NO NO TICE TICE TICE
Be careful not to damage the network cable when connecting it.
7. If the RJ45 Push-pull Connector (IP66) has not been connected to the network cable,
see the instructions supplied with the connector. For information how to assemble an
IP66-rated RJ45 connector, see page 19.
8. Connect the network cable.
9. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
10. Secure the network camera to the mounting bracket by tightening the screws.
AXIS Q60-E Series
17