SilverStone PT15 Serie Manual Del Usuario

VESA mount installation procedure
2
Secure VESA mount bracket with four С помощью четырех винтов закрепите
screws on rear of monitor. монтажный кронштейн VESA на задней
панели монитора.
VESA-Montagehalterung mit vier
將VESA背板以四顆螺絲鎖固於螢幕後方。
Schrauben an der Rückseite des Monitors
befestigen.
Vissez la console de montage VESA avec
将VESA背板以四颗螺丝锁固于屏幕后方。
les quatre vis à l'arrière de l'écran.
Fije el bracket de la montura VESA con
VESAマウントブラケットをモニタ後部
cuatro tornillos a la parte trasera del
にネジ4本で固定します。
monitor.
Fissare il supporto VESA con quattro viti
네 개의 나사를 사용하여 VESA 장착
alla parte posteriore del monitor.
브래킷을 모니터의 후면에 고정합니다.
3
Align and push PT15 into the VESA Выровняйте и установите PT15 в
bracket, than push downward to complete кронштейн VESA, затем нажмите
installation. вниз для окончательной установки.
PT15 an der VESA-Halterung ausrichten
先將PT15對齊VESA背板後推入，
und drücken; dann zum Abschließen der
再往下扣住背板即可完成安裝。
Installation nach unten drücken.
Alignez et poussez le PT15 dans la
先将PT15对齐VESA背板后推入，
console VESA, puis poussez vers le bas 再往下扣住背板即可完成安装。
pour terminer l'installation.
Alinee y presione la PT15 contra el bracket
PT15をVESAブラケットに合わせて押
VESA, luego presione hacia abajo para
さえ、下方に押して装着は完了です。
completar la instalación.
Allineare e spingere PT15 ne supporto
PT15를 VESA 브래킷에 맞춰 정렬하여
VESA, quindi spingere verso il basso per
밀어 넣은 후 아래로 눌러 설치를 완료합니다.
completare l'installazione.
Warranty Information
This product has a limited 3 year warranty in North America, Europe, and Australia.
For information on warranty periods in other regions, please contact your reseller or SilverStone authorized distributor.
Warranty terms & conditions
1. Product component defects or damages resulted from defective production is covered under warranty.
Defects or damages with the following conditions will be fixed or replaced under SilverStone Technology's jurisdiction.
a) Usage in accordance with instructions provided in this manual, with no misuse, overuse, or other inappropriate actions.
b) Damage not caused by natural disaster (thunder, fire, earthquake, flood, salt, wind, insect, animals, etc...)
c) Product is not disassembled, modified, or fixed. Components not disassembled or replaced.
d) Warranty mark/stickers are not removed or broken.
Loss or damages resulted from conditions other than ones listed above are not covered under warranty.
2. Under warranty, SilverStone Technology's maximum liability is limited to the current market value for the product (depreciated value, excluding
shipping, handling, and other fees). SilverStone Technology is not responsible for other damages or loss associated with the use of product.
3. Under warranty, SilverStone Technology is obligated to repair or replace its defective products. Under no circumstances will SilverStone
Technology be liable for damages in connection with the sale, purchase, or use including but not limited to loss of data, loss of business, loss of
profits, loss of use of the product or incidental or consequential damage whether or not foreseeable and whether or not based on breach of warranty,
contract or negligence, even if SilverStone Technology has been advised of the possibility of such damages.
4. Warranty covers only the original purchaser through authorized SilverStone distributors and resellers and is not transferable to a second hand
purchaser.
5. You must provide sales receipt or invoice with clear indication of purchase date to determine warranty eligibility.
6. If a problem develops during the warranty period, please contact your retailer/reseller/SilverStone authorized distributors or SilverStone
http://www.silverstonetek.com.
Please note that: (i) You must provide proof of original purchase of the product by a dated itemized receipt; (ii) You shall bear the cost of shipping
(or otherwise transporting) the product to SilverStone authorized distributors. SilverStone authorized distributors will bear the cost of shipping
(or otherwise transporting) the product back to you after completing the warranty service; (iii) Before you send the product, you must be issued a
Return Merchandise Authorization ("RMA") number from SilverStone. Updated warranty information will be posted on SilverStone's official website.
Please visit http://www.silverstonetek.com for the latest updates.
Additional info & contacts
For North America (usasupport@silverstonetek.com)
SilverStone T echnology in North America may repair or replace defective product with refurbished product that is not new but has been functionally tested.
Replacement product will be warranted for remainder of the warranty period or thirty days, whichever is longer. All products should be sent
back to the place of purchase if it is within 30 days of purchase, after 30 days, customers need to initiate RMA procedure with SilverStone T echnology
in USA by first downloading the "USA RMA form for end-users" form from the below link and follow its instructions.
http://silverstonetek.com/contactus.php
For Australia only (support@silverstonetek.com)
Our goods come with guarantees that cannot be excluded under the Australian Consumer Law.
You are entitled to a replacement or refund for a major failure and for compensation for any other reasonably foreseeable loss or damage.
You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.
Please refer to above "Warranty terms & conditions" for further warranty details.
SilverStone T echnology Co., Ltd. 12F No. 168 Jiankang Rd., Zhonghe Dist., New T aipei City 235 T aiwan R.O.C. + 886-2-8228-1238
(standard international call charges apply)
For Europe (support.eu@silverstonetek.de)
For all other regions (support@silverstonetek.com
)
P r e m i u m a l u m i n u m c a s e
f o r I n t e l N U C m o t h e r b o a r d s
PT15
Compatible with most Intel NUC motherboards
Premium aluminum construction & SilverStone styling
Pre-assembled WIFI antenna and Bluetooth for ease of deployment
Super small design at 130mm x 110mm x 41mm
Includes VESA MISD-75 mounting bracket
Supports DIN rail mounting
PT15B-H1D1
PT15B-D2
NUC
NEXT UNIT OF COMPUTING
PT15B-H1D2
PT15B-H2
NO.G11221091