Kermi Ideos IDV10 Instrucciones De Operación E Instalación página 7

Suspend and align the radiator (see Fig. 16–20)
When aligning take the position of the con-
necting pipes into account. It must be possible
to screw the two clamp connections without
any difficulty onto the thread of the screw con-
nection and no tensions may arise in the con-
necting pipes.
Put two clamp connections (not included in
►
the scope of delivery) onto the connecting
pipes.
Suspend the radiator via the screws into
►
the retainers. Ensure that the radiator does
latch in.
► In order to align the radiator sideways:
Slide the retainers.
In order to set the wall clearance: Pull out
►
or push in the retainers.
In order to set the height: Turn the adjust-
►
ing screw at the retainer.
Install the lower spacers and fasten the radia-
tor (see Fig. 21–30)
Turn out the lower spacers until these are
►
positioned flat at the wall and the radiator
hangs straight.
► Tighten the upper securing screws.
► Mark the lower drill holes for the spacers.
Press the locking clamp to the rear and hang
►
out the radiator. Put down the radiator so
that the thermostat head and the heating
element (IDV11) are not damaged.
Drill the holes and insert the anchors at the
►
lower markings.
Dismantle both spacers.
►
Screw both snap-in bolts tight.
►
► Suspend the radiator via the screws into
the retainers. Ensure that the radiator does
latch in.
Press on both cover caps and slide them to
►
the rear.
Press the wall support clips onto both spacers.
►
Connection (see Fig. 31)
Screw the two clamp connections tight.
►
Completing activities (see Fig. 32)
Cover the radiator completely with the pro-
►
tective packaging.
Commissioning
Remove the protective packaging com-
►
pletely before final cleaning or commis-
sioning.
Fill the radiators and vent them using the
►
bleeding (E). Risk of scalding!
Check the radiator and connections for leaks.
►
Electrical connection (with auxiliary electrical
operation)
Have the following activities carried out by
►
an electrician (in accordance with the sepa-
rate instructions):
–
Installation and connection of the elec-
trical unit
–
Connection of the heating element to
the electrical unit
7