Installation; Rear Spacers; Electrical Connection - AEG S63600CMM1 Manual De Instrucciones

INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
POSITIONING
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
LOCATION
A

REAR SPACERS

ELECTRICAL CONNECTION

Before plugging in, ensure that the volt-
age and frequency shown on the rating
All manuals and user guides at all-guides.com
B
2
1
3
4
Cli- Ambient temperature
mate
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
The appliance should be installed well
away from sources of heat such as radia-
tors, boilers, direct sunlight etc. Ensure
that air can circulate freely around the
back of the cabinet. To ensure best per-
formance, if the appliance is positioned
below an overhanging wall unit, the mini-
mum distance between the top of the
cabinet and the wall unit must be at least
100 mm . Ideally, however, the appliance
should not be positioned below over-
hanging wall units. Accurate levelling is
ensured by one or more adjustable feet at
the base of the cabinet.
WARNING!
It must be possible to disconnect
the appliance from the mains
power supply; the plug must
therefore be easily accessible af-
ter installation.
You can find the two spacers in the bag
with documentation.
Do these steps to install the spacers:
1. Release the screw.
Engage the spacer below the screw.
2.
3. Turn the spacer to the right position.
4. Tighten again the screws.
plate correspond to your domestic power
supply.
The appliance must be earthed. The pow-
er supply cable plug is provided with a
ENGLISH
21