Tabla de contenido
Publicidad
Product modification
Minor modifications may be necessary to tailor the retractable screen to your
application. Door trim openings that measure less than 68" will require track
cutting to fit the door width. Outswing door installations require a change to the
handle/lock assembly to move the lock mechanism to the inside of the home.
NARROW DOOR
TRACK MODIFICATION
Measure your door trim opening and
follow the example below to make
your modifications. Cut the ends of
the tracks that will be inserted into
the decorative housing.
EXAMPLE
68"
standard door width
-66"
existing door width
= 2"
+ 1-7/8"
= 3-7/8"
total amount to be cut
from the ends of the
top and bottom tracks
OUTSWING DOOR
HANDLE MODIFICATION
Once the unit is installed, follow these
steps to move the lock mechanism to
the inside of the home.
Engage the lock and remove the
(2) screws from the handle.
Remove both handles
(the grey latch will be loose).
Remove the latch from the
slider bar and reverse it so
the logo faces the inside the
home. Then press the latch
over the slider bar.
Place the handle with the lock
on the logo side of the latch.
Align and insert the screws through
the screw holes. Position the remaining
handle over the screws and align the
(6) small dimples with corresponding
indentations on the other handle.
Tighten the (2) screws.
8
Publicidad
Tabla de contenido
