Fein ASte 638 Manual De Instrucciones página 10

ASt/e 638 - (069) - Buch Seite 10 Freitag, 7. November 2003 12:37 12
EN
Operating instructions for jigsaw.
Overview.
1 Setting the stroke (ASte 638)
Infinitely variable number of strokes
from 1050/min (= 1) to
2600/min (= 6).
2 Switch
For switching ON/OFF.
3 Handle
Hold the power tool firmly. Unscrew
the handle and either loosen or tighten
the saw blade as required.
4 Chipping protector
Protects the user from chips.
5 Rigid saw-blade guide
Saw-blade holder.
6 Hose sleeve
(for connecting to dust extraction)
Connect dust extraction. Set the
direction of flow.
7 Shoe plate
Can be mounted turned through 180°.
8 Supplied accessories
Chipping protector (h).
Anti-chipping protector (i).
Saw blades for steel up to 10 mm (j).
Saw blades for steel up to 2 mm (k).
For your safety.
Before using this power tool, read
and comply with:
these operating instructions,
the enclosed safety instructions
(document number 3 41 30 054 06 1),
the relevant national industrial safety
regulations.
10
ASte 638 / ASt 638
These operating instructions and the
enclosed safety information should be
kept carefully for later use and enclosed
with the machine, should it be passed on
or sold.
Intended use.
This device is intended for:
commercial use in industry and trade,
for sawing wood, plastic and metal (maxi-
mum cutting capacities are listed in the
Specifications),
for applications using the saw blades and
accessories given in these operating
instructions or those recommended by
FEIN.
Safety instructions.
!
Risk of injury
Only set the power tool onto the work-
piece when it is switched on.
Only use saw blades that are sharp and
not damaged. Choose the saw blade and
stroke to suit the material to be cut.
The saw blade can become very hot dur-
ing the sawing process.
Provide for a secure stance; clamp the
material to be worked firmly.
Do not treat any materials that produce
any particles that are detrimental to health
(e. g. asbestos).
Never allow the hand or fingers to slip in
front of the saw blade while working.
While sawing, the shoe plate (7) must lie
flat over its entire surface.
Danger of kick-back! After finishing work,
switch off the power tool and wait for the
saw blade to come to a standstill before
removing it from the cut.
Do not rivet or screw any name-plates or
signs onto the power tool. The protective
insulation can thereby be rendered inef-
fective. Adhesive labels are recom-
mended.
Only use an undamaged plug and cable.