Compactor Care; Cleaning - Kenmore 665.1472 Serie Manual De Uso Y Cuidado

2. Put bag caddy into drawer.
A. Bag caddy inside drawer
3. Place either a plastic or paper bag into the drawer.
If using a paper bag, open bag and pull top edges over
the drawer top. Slide front edge of bag over front edge
of drawer. Slide rear edge over rear of drawer.
If using plastic bag, open bag and pull top edges over
drawer top. Lock bag into place by pulling the
Your new compactor is designed to give you many years of
dependable service. However, there are a few things you are
expected to do in order to properly maintain your compactor.
This section will tell you how to clean and care for your
compactor.

Cleaning

Before cleaning the compactor, turn the Key-Knob (or Key-
Switch) to the OFF & LOCK position and remove it.
NOTE: Any services other than those outlined in this section
should be performed by a designated service representative.
Cleaning Exterior Surfaces
1. Wash exterior surfaces (including stainless steel) with a
clean sponge or soft cloth and a mild detergent in warm
water. Do not use abrasive or harsh cleaners. Rinse and dry
thoroughly with a soft cloth.
2. Wipe up spills right away. Some foods can damage the
finish if left on the compactor surface.
Cleaning Inside the Drawer
NOTE: You may want to wear gloves since there may be bits of
glass in the drawer.
1. Remove the bag. See "Removing a Filled Bag."
2. Press down on the lever-action lock (or Side-Lock latch).
A

COMPACTOR CARE

4 prepunched holes over the bag retainer buttons. Holes
will expand over buttons without harming bag.
Installing paper bag
4. Press inside of bag against the drawer bottom, sides and
corners for a smooth fit.
3. Hold the lever-action lock down and tilt the side of the
drawer out until the lock clears the drawer front.
NOTE: If desired, the drawer side can be removed by tilting
it up, then lifting it out.
4. Wash the interior of the drawer with a clean sponge or soft
cloth and a mild detergent in warm water. Rinse and dry
thoroughly with a soft cloth.
5. If the drawer side was removed, slide it back into the tilted
position.
6. Press the lever-action lock (or Side-Lock Latch) down while
pushing the drawer side to the upright position.
7. Latch the drawer side by pushing up the lever-action lock (or
Side-Lock Latch).
Installing plastic bag
13