Maintenance And Cleaning - Würth Master WDM 61 Instrucciones Para El Manejo

WDM 61.book Seite 18 Mittwoch, 28. Mai 2008 8:08 08

Maintenance and Cleaning

Do not use aggressive cleaning agents; use a
soft, moist cloth.
Clean the optics using a cleaning cloth for
glasses or lenses.
Do not attempt to open the device.
If the machine should happen to fail despite the
care taken in manufacture and testing, repair
Trouble Shooting/Corrective Action
Indication Cause
204 Calculation error
252/253 Temperature not within the per-
mitted range
255 Receive signal too weak, Measur-
ing period too long
256 Receive signal too strong
257 Measuring error, ambient light
too bright
258 Not within the measuring range
260 Laser beam was interrupted dur-
ing measurement
ERROR Hardware error
18
should be carried out by an authorized cus-
tomer service agent for Würth power tools.
For all correspondence and spare parts orders,
always include the article number on the type
plate of the machine.
For the current spare parts list of this machine,
log into the Internet
www.wuerth.com/partsmanager" or ask for a
copy at your nearest Würth branch office.
Corrective Action
Conflict of units: Lengths miscalculated with
areas and volume
Allow tool to cool down/warm up
Use target plate (accessory)
Use target plate (accessory)
Carry out measurement under other light condi-
tions
Reduce distance
Repeat measurement
Switch the tool off and on again; if required, sev-
eral times. If the error symbol does not go out,
contact Würth customer service agent.
under "http://