Maintenance And Cleaning - Würth Master WDM 101 Instrucciones Para El Manejo

All manuals and user guides at all-guides.com
WDM 101 - Buch Seite 20 Dienstag, 8. Januar 2008 1:36 13
The auxiliary measurements and result l
indicated in the display.
Automatic Release (Timer)
The automatic release can be used when meas-
uring and holding the target plate at the same
time is required.
– Press pushbutton briefly to start a 5 second
countdown.
– By pressing buttons
can be prolonged to 60 seconds.
The countdown starts immediately after releas-
ing the button or, when the laser was not acti-
vated, after pressing button
Each of the last 5 seconds is indicated acousti-
cally.
Determining a Solid Angle
The angle in a triangle can be calculated by
measuring the three sides. This function, as an
example, can be used for checking α
right-angled solid angle α.
– Press pushbutton until the
appears in the display. Mark the marking
point right and left of the angle to be meas-
ured.
Trouble Shooting/Corrective Action
Indication Cause
156 Lateral inclination greater than 10°
160 Angle value too large
204 Calculation error
252/253 Temperature not within the permitted range
255 Receive signal too weak, Measuring period too
long, distance longer than 100 m
256 Receive signal too strong
257 Measuring error, ambient light too bright
260 Laser beam was interrupted during measure-
ment
Hardware error
20
are – Position the device on each side respectively,
1
press the
of the short distances (d
another.
– Position the device, press the
and measure the long distance (d
The auxiliary measurements and result are indi-
cated in the display.

Maintenance and Cleaning

, the countdown
Do not use aggressive cleaning agents; use a
soft, moist cloth.
Clean the optics using a cleaning cloth for
.
glasses or lenses.
Do not attempt to open the device.
If the machine should happen to fail despite the
care taken in manufacture and testing, repair
F
should be carried out by an authorized cus-
tomer service agent for Würth power tools.
For all correspondence and spare parts orders,
always include the article number on the type
plate of the machine.
symbol
For the current spare parts list of this machine,
log into
www.wuerth.com/partsmanager" or ask for a
copy at your nearest Würth branch office.
Corrective Action
Hold device level (not laterally inclined)
Measure angles to 45 ° max.
Conflict of units: Lengths miscalculated with areas
and volume
Allow tool to cool down/warm up
Use target plate (accessory)
Use target plate (accessory)
Carry out measurement under other light condi-
tions
Repeat measurement
Switch the tool off and on again; if required, sev-
eral times. If the error symbol does not go out, con-
tact Würth customer service agent.
pushbutton and measure both
, d ) one after
1 2
pushbutton
).
3
the Internet under "http://