Cequent Performance Products 30156 Instrucciones página 4

ADAPTER REMOVAL
1. Remove lynch pin / lock from the overlapping handle holes on each side of the adapter (Figure 3c). Store
lynch pins.
2. Rotate (4) handles into unlocked position (parallel with base tube, Figure 3a). Lift each side of adapter out
of pucks separately, handles may have to be worked slightly to align anchors with puck holes to remove.
3. Store adapter in dry place where dirt and debris will not get into anchor assemblies.
4. Press puck plugs (packed with mounting kit) into all (4) of the pucks in the truck bed to keep debris out of
pucks (Figure 4).
BEFORE EACH TRIP
1. Lube feet with lithium grease for easier engagement as shown in Figure 6
2. Before each trip or maneuver, check to make sure both the Tee pin arms as well as the pull pin (included in
fifth wheel hitch hardware bag) are in place and have respective lynch pins locked in place.
3. Review operation manuals for both the fifth wheel hitch being used, and the corresponding Elite or Signature
Series mounting kit being used.
Pull pins are in position, locking
arches and adapter together,
spring clips are in corresponding
groove in pull pin
© 2011 Cequent Performance Products, Inc. Made in XXX
SHEET 4 OF 5
30156N
Arms are in locked
position and lynch pin is
secured in place
Figure 5
Lube Points
08-08-11
Figure 6
Rev. A