NORTH STATES 8670 Instrucciones página 4

Step 4
To attach the hinge side of the gate to the mounting sockets, refer to Figure 4. Note, to align the hinge posts over the mounting
sockets, the gate must be at a 45-90 degree angle to the plane of the opening. Once the hinge posts are aligned over the
mounting sockets (Figure 5), set the gate into place. The gate can be removed from the opening by reversing this procedure.
STAIRS
SIDE
FIGURE 4
Check to see that the release handle is positioned properly (Figure 6). If not, simply remove the two screws holding it into place,
and move it to the top side of the gate, installing it with the two screws you previously removed.
NOTE: When installing the gate, the release handle must be on the side away from child.
SIDE
Operating the Gate
TO CLOSE GATE
FIGURE 7
CLEANING INSTRUCTIONS: Wash with warm water using mild liquid soap. Use a soft cloth to avoid scratching the gate. Rinse
with clear water and wipe dry with a soft cloth. NOTE: Never use solvents, chemicals, scouring powders or sharp tools when
cleaning the gate.
AT LEAST
HANDLE
HANDLE
FIGURE 6
To lock the gate, align the locking pegs over
the mounting sockets (Figure 7) and set the
gate into place. Make sure that each time
you use the gate, both the top and bottom
locking pegs are set into the mounting
sockets. Test your installation by pulling up
on both the hinge and locking sides of the
gate to make sure you can't dislodge either
side.
To unlock the gate, pull back on the release
handle (and the panel it is attached to) until
the release handle clears the mounting
socket. Then lift the gate panel until the
locking pegs clear the sockets (Figure 8).
FIGURE 5
TO OPEN GATE
FIGURE 8
Page 4
SIDE