Tabla de contenido
Publicidad
Retrofit cabinet user's guide
www.renishaw.com
Installation
The installation of the retrofit cabinet should only be performed by Renishaw or a Renishaw certified installation engineer.
Connection of CMM to the cabinet is either through an interface PCB or directly to the UCC / SPA units inside.
Refer to the relevant installation guides for the equipment to be fitted:
www.renishaw.com/cmmguides
To ease installation it is possible to remove the side panels from the cabinet by unlocking them with the keys provided.
The cabinet can be used in conjunction with the Renishaw retrofit desk.
CAUTION: The control cabinet, whether empty or equipped, exceeds the limits for a two person lift. Please follow the instructions
on the outer packaging in order to remove the cabinet from the pallet. The cabinet has been provided with integral wheels for
moving it around. It is not permitted to lift a cabinet with lifting equipment - no lifting points are provided.
The installation engineer is responsible for positioning the cabinet correctly. Should it need moving you must do the following:
Ensure a minimum clearance of 300 mm around all sides
Keep cables tidy, secure from being easily pulled out and not anywhere where they may present a trip hazard
Keep the working environment within specified environmental conditions
Always match the cabinet to the CMM as the cabinet is configured specifically for each CMM installation
Lock the cabinet wheels to prevent accidental movement
Review the risk assessment
A unique set of keys are provided with the retrofit cabinet (spares are available from Renishaw)
Issued 07 2021
17
Publicidad
Tabla de contenido
