Renishaw H-1000-5186-05-A Guía De Usuario página 21

Retrofit cabinet user's guide
www.renishaw.com
Isolation
CAUTION: Remove electrical power from the cabinet before opening or removing any panel. Power is removed by disconnecting
the mains leads on the rear panel (refer to the 'Installation' section).
The power switch is used to switch off the power to the internal equipment. If an additional means of isolation is required, it must be specified
and fitted by the machine manufacturer or the installer of the product. The isolator must be sited within easy reach of the CMM operator and
comply with IEC61010 and any applicable national wiring regulations for the country of installation.
CAUTION: If this switch is intended for use as an emergency isolation switch, then the door of the cabinet should be removed.
Issued 07 2021
21