Flex XFE 15 125 18.0-EC Instrucciones De Funcionamiento Originales página 24

Regularly clean the filter cover.

Remove filter cover and blow it out with
dry compressed air.
Gears
NOTE
Do not loosen the screws on the gear head
during the warranty period.
Non-compliance will deem the guarantee
obligations of the manufacturer null and void.
Replacement of wear parts
Change Velcro pad
Remove the battery.

Remove the polishing tool.

Place machine on its back.

Release and remove screws with Torx

wrench (1.).
Remove worn Velcro pad (2.).

Remove contaminants from interior.

24
XFE 15 125 18.0-EC / XFE 15 150 18.0-EC / XCE 8 125 18.0-EC
Align securing holes and fit new Velcro

pad (3.).
Insert screws and tighten with Torx

wrench (4.). (Tightening torque 2.5-3.0 Nm
(1.8-2.2 ft. lb.))
Carry out test run. Check for imbalances

and vibrations.
CAUTION!
An incorrect torque setting can damage the
tool and the surfaces being worked on.
Repairs
Repairs may be carried out by an authorised
customer service centre only.