Yoke Cover; Set Screw; Yoke - Honeywell 50614 Guia Del Usuario

STANDARD OR ANGLE MOUNT INSTRUCTIONS
1. Remove the downrod pin and downrod clip from the downrod. Then partially loosen the set screws in the yoke at the top of the
motor assembly (Figure 3.1).
2. Feed the fan wires through the yoke cover, canopy and downrod (Figure 3.2).
3. Slide the downrod into the yoke of the motor assembly. Align holes and reinstall the downrod pin and downrod clip and secure
with the two set screws (Figure 3.3).
4. Depending on the length of downrod you use, you may want to cut the fan wires to simplify wiring. After pulling the wires all
the way through the downrod, measure 8 inches of wire. Cut off the excess wire using wire cutters (not included) (Figure 3.4).
5. Install the ball end of the downrod into the opening of the mounting bracket (Figure 3.5). WARNING: Failure to align the slot
in the ball with the tap on the mounting bracket may cause the fan to fall, which could result in injury or death.
Skip to FINAL INSTALLATION, page 6.
Downrod
Clip
Downrod
Pin
Figure 3.1
Figure 3.4

Set Screw

Yoke Cover

Yoke

Figure 3.2
8 in.
Downrod
Figure 3.5
Downrod
Canopy
Mounting
Bracket
Slot
Tab
5
Downrod
Downrod Clip
Figure 3.3
Set Screw
Downrod Pin