HURAKAN HKN-GX650TN INOX Manual Del Usuario página 14

EN
Safety Tips
⚫
Position on a flat, stable surface.
⚫
A service agent/qualified technician should carry out installation and any repairs if
required. Do not remove any components or service panels on this product.
⚫
Consult Local and National Standards to comply with the following:
· Health and Safety at Work Legislation
· BS EN Codes of Practice
· Fire Precautions
· IEE Wiring Regulations
· Building Regulations
⚫
DO NOT use jet/pressure washers to clean the appliance.
⚫
DO NOT use the appliance outside.
⚫
DO NOT use this appliance to store medical supplies.
⚫
DO NOT use electrical appliances inside the appliance. (e.g. heaters, ice-cream makers
etc.)
⚫
DO NOT stand or support yourself on the base, drawers or doors.
⚫
DO NOT allow oil or fat to come into contact with the plastic components or door seal.
Clean immediately if contact occurs.
⚫
Bottles that contain a high percentage of alcohol must be sealed and placed vertically in
the refrigerator.
⚫
Always carry, store and handle the appliance in a vertical position and move by holding
the base of the appliance.
⚫
Always switch off and disconnect the power supply to the unit before cleaning.
⚫
Keep all packing away from children. Dispose of the packaging in accordance with the
regulations of local authorities. If the power cord is damaged, it must be replaced by an
agent or a recommended qualified technician in order to avoid a hazard.
Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and
operation of this machine will provide the best possible performance from your product.
Pack Contents
· Refrigerator or Freezer
· Shelves x 3 (Single) / x 6 (Double)
· Keys x 2
· Instruction manual
· Shelf guides x 6 (Single) / x 12 (Double)
· Waste water tray
We pride ourselves on quality and service, ensuring that at the time of packing the contents
are supplied fully functional and free of damage. Should you find any damage as a result of
transit, please contact your dealer immediately.
Installation
Note: If the appliance has not been stored or moved in an upright position, let it stand upright
for approximately 12 hours before operation. If in doubt allow the appliance to stand.
1. Remove the appliance from the packaging. Make sure that all protective plastic film and
coatings are thoroughly removed from all surfaces.
12