Ego Power+ LM1700E Manual Del Operador página 14

2. Switch Lever
EN
3. Safety Button
4. Handle
5. Full-grass Indicator
6. Grass Bag Handle
7. Rear-Discharge Door
8. Rear Handle
9. Battery-Pack Cover
10. Front Wheel
11. Mower Deck
12. LED Headlights
13. Rear Wheel
14. Cutting-Height Adjustment Lever
15. Grass Bag
16. Quick-Adjust Lever
17. Side Rail
18. Handle-Locking Clamp
19. Self-propel Speed-control Knob
20. Bail Switcg (Switch Lever)
21. Side Rail
22. Safety Button
23. Safety Key Slot
24. Battery-Release Button
25. Switch Button for LED Headlights
26. Power Indicator
OPERATION
ASSEMBLING THE GRASS BAG
1) Assemble the two side clips and the bottom clip to
the frame (Fig. D).
D-1 Bottom Clip
D-2 Frame
2) Align the ribs with the mounting slots on the bag cover
and press the rib down until you hear a "click" (Fig. E).
E-1 Ribs
E-2 Mounting Slot
NOTICE:
Under normal usage, bag material is subject to
wear. To reduce the risk of injury, frequently inspect the
bag assembly and replace if there are any signs of wear
or deterioration. Use only grass bags manufactured for
this mower.
ADJUSTING THE FOLDABLE HANDLE
WARNING:
Do not attempt to start the mower until
the handle has been locked at one of the three preset
operating positions (UPPER OPERATING POSITION, MIDDLE
OPERATING POSITION and LOWER OPERATING POSITION).
14
56 VOLT LITHIUM-ION CORDLESS MOWER — LM1700E/LM1700E-SP
D-3 Side Clips
E-3 Bag Cover
Your mower is shipped with the handle in the compact,
LOCKED STORAGE POSITION (Fig. F).
1) Press and hold the quick-adjust lever to release the
handle from the LOCKED STORAGE POSITION.
2) Lift the handle from its folded position, then release
the lever. Gently pivot the handle upward until you hear
and feel the lock pin engage in one of the following
different positions as shown in the Fig. G.
Fig. G parts description see below:
G-1 Locked Storage G-4
Position
G-2 Grass Bag G-5
Attachment/Removal
Position
G-3 Upper Operating G-6
Position
ATTACHING THE GRASS BAG
WARNING:
Do not at any time make any adjustment
to the lawn mower without first stopping the motor,
removing the safety key and waiting for the blade to stop
rotating.
NOTICE: Attac
any of the attachments to the lawn
h
mower before mowing.
◾
To Attach/Remove the Grass Bag (Fig. H1 & H2)
Insert the board of the grass bag into the mower and
hang the grass bag on the mower.
NOTICE:
Remove the mulching insert (Need to be
purchased separately) from the mower before attaching the
grass bag to the mower.
◾
To Attach/Remove the Mulching Insert (Fig. I)
Lift the rear-discharge door and insert the mulching insert
into the mower. To remove, just pull it out. Lastly, release
the rear-discharge door.
ADJUSTING THE CUTTING HEIGHT (Fig. G)
WARNING:
Keep your feet away from the deck when
adjusting its height. The mower can be set to 7 cutting
heights between 20mm and 80mm. Choose the proper
cutting height according to the types and conditions of the
grass.
NOTICE:
When moving the tool, make sure the cutting
height is adjusted at the position of 3 or higher. Failure to do
so, could result in the damage of the blade.
Middle Operating
Position
Lower Operating
Position
Cutting Height
Adjusting Level