Ego Power+ LM1900E Manual Del Operador página 14

13. Quick-Adjust Lever
EN
14. Handle-Locking Clamp
15. Self-propel Speed-control Knob
16. Bail Switcg (Switch Lever)
17. Side Rail
18. Safety Button
19. Self-propel Switch
20. Safety Key Slot
21. Battery-Release Button
22. Switch Button for LED Headlights
23. Power Indicator
OPERATION
ASSEMBLING THE GRASS BAG
1) Assemble the two side clips and the bottom clip to
the frame (Fig. D).
D-1 Bottom Clip
D-2 Frame
2) Align the ribs with the mounting slots on the bag cover
and press the rib down until you hear a "click". (Fig. E).
E-1 Ribs
E-2 Mounting Slot
NOTICE:
Under normal usage, bag material is subject to
wear. To reduce the risk of injury, frequently inspect the
bag assembly and replace if there are any signs of wear
or deterioration. Use only grass bags manufactured for
this mower.
ADJUSTING THE FOLDABLE HANDLE
WARNING:
Do not attempt to start the mower until
the handle has been locked at one of the three preset
operating positions (UPPER OPERATING POSITION, MIDDLE
OPERATING POSITION and LOWER OPERATING POSITION).
Your mower is shipped with the handle in the compact,
LOCKED STORAGE POSITION (Fig. F).
1) Press and hold the quick-adjust lever to release the
handle from the LOCKED STORAGE POSITION.
2) Lift the handle from its folded position, then release
the lever. Gently pivot the handle upward until you hear
and feel the lock pin engage in one of the following
different positions as shown in the Fig. G.
Fig. G parts description see below:
G-1 Locked Storage
Position
14
56 VOLT LITHIUM-ION CORDLESS MOWER — LM1900E/LM1900E-SP
D-3 Side Clips
E-3 Bag Cover
G-4 Middle Operating
Position
G-2 Grass Bag G-5
Attachment/
Removal Position
G-3 Upper Operating G-6
Position
ATTACHING THE GRASS BAG/MULCHING INSERT
WARNING:
Do not at any time make any adjustment
to the lawn mower without first stopping the motor,
removing the safety key and waiting for the blade to stop
rotating.
NOTICE:
Attach any of the attachments to the lawn mower
before mowing.
◾
To Attach/Remove the Grass Bag (Fig. H1 & H2)
Insert the board of the grass bag into the mower and hang
the grass bag on the mower.
NOTICE: Remove the mulching insert (Need to be
purchased separately) from the mower before attaching
the grass bag to the mower.
◾
To Attach/Remove the Mulching Insert (Fig. I)
Lift the rear-discharge door and insert the mulching insert
into the mower. To remove, just pull it out. Lastly, release
the rear-discharge door.
ADJUSTING THE CUTTING HEIGHT (Fig. G)
WARNING:
Keep your feet away from the deck when
adjusting its height. The mower can be set to 7 cutting heights
between 20mm and 80mm. Choose the proper cutting height
according to the types and conditions of the grass.
NOTICE:
When moving the tool, make sure the cutting
height is adjusted at the position of 3 or higher. Failure to
do so, could result in the damage of the blade.
ATTACHING/DETACHING THE BATTERY PACK (Fig. J)
CHARGE BEFORE FIRST USE.
WARNING:
If any parts are broken or missing, do not
attempt to attach the battery pack to the mower or operate
the mower until the broken or missing parts are replaced.
Failure to do so could result in serious injury.
◾
To Attach
Push the battery pack into the battery compartment until
you hear a "click".
Lower Operating
Position
Cutting Height
Adjusting Level