Chauvet Professional EPIX DRIVE 642 Guía De Referencia Rápida página 9

ÉPIX™ Drive 642 QRG
Connecting
ÉPIX™
Products to the
Power Supply
The ÉPIX™ Drive 642 uses an RJ45 data connection to link all data ports.
You can connect either 4 ÉPIX™ Strip 2.0 or 1 ÉPIX™ Bar 2.0 or
4 ÉPIX™ Tile 2.0 per output on the ÉPIX™ Drive 642. The following
diagram illustrates how to assemble the data connections.
Each port of ÉPIX™ Drive 642 can support 1 ÉPIX™ Bar 2.0 or
4 ÉPIX™ Strip 2.0 or 1 ÉPIX™ Tile 2.0. Make sure the total length of
the connecting network cables (RJ45) does not exceed 10 meters.
Be sure power is disconnected from the ÉPIX™ Drive 642 before
connecting any ÉPIX™ 2.0 products. Failure to do so may cause
damage and void your warranty.
Length of each
cable cannot
exceed 10 m
9
EN
Total length of
cables cannot
exceed 10 m
Total length of
cables cannot
exceed 10 m