Installing And Removing The Batteries - Pioneer SGY-PM910H2 Manual De Usuario

Installing and Removing the Batteries

EN
The batteries are pre-installed to this product. If the batteries are almost
empty (see Page 28 for how to confirm), replace the batteries with new ones
by the following procedure.
• Replace the batteries of both the left and right sensors at the same time.
1. Remove the cover.
• Be careful not to drop or lose the
battery when removing the cover.
• Right transmitter (screws: 3 x)
Use a hex wrench (2 mm) to loosen
the screw and remove the cover.
• Be careful not to lose the removed
screw.
• Do not lose the water-proof packing.
12
• Left transmitter
Turn the cover to the left so the
triangular arrow points to [OPEN]
and remove it.