Switching Modes - Pioneer SGY-PM910H2 Manual De Usuario

Ocultar thumbs Ver también para SGY-PM910H2:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 162
EN

Switching modes

• When using SGX-CA500, the firmware version is required to be 20150501.02.43 or
higher.
• Pedaling monitor mode (Page 15)
Can be switched with SGX-CA500. Cannot be switched with cyclocomputers from
other manufacturers. When the mode is switched to pedaling mode, the LEDs on the
sensors light green for 10 seconds.
Current mode
Dual power meter
Single power meter
• Dual power meter mode (Page 19)
The mode can be switched on SGX-CA500 or by operating the right sensor push
switch. When using with another manufacturer's Cyclocomputer, switch using
method 1. When the mode is switched to powermeter mode, the LEDs light orange
for 10 seconds.
Current mode
Pedaling monitor
Single power meter
4
Method 1
(Right sensor push switch)
Cannot be switched
Cannot be switched
Method 1
(Right sensor push switch)
Cannot be switched
Method 2
lighting
(SGX-CA500)
method
The LEDs light
green for 10
seconds
Method 2
lighting
(SGX-CA500)
method
The LEDs light
orange for 10
seconds
LED
LED

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Sgy-pm910hlSgy-pm910hr

Tabla de contenido