Bimar VR32 Folleto De Instrucciones página 22

• In case of a fault or malfunction, switch the appliance off and have it checked by
qualified staff; repairs by unqualified staff may be dangerous and lead to the loss of
warranty cover.
• The appliance comprises the following parts:
Warning: before assembling the appliance, make sure that it is disconnected from the
power socket.
Base (see diagrams for assembly): place one half of the casing on the body to align
-
its 4 holes with the body and add the other half of the casing, overlapping one end
(A) with the other end underneath (B) and fully inserted; fix with the 6 screws
provided. When done, check that the two halves of the casing are correctly
assembled on the body.
3 litre water tank, with clear window and Min&Max level marks (2), the adjustable
-
water filler inlet (4) is in the rear; press the hook and extract outwards to open. Fill
with demineralised water (free from lime) and free from additives (fragrances,
detergents, etc.), not above the max level (5) (about 3L) and not below the min
level (6) (about 1/1.5 litre). The 2 ice blocks (6) supplied can be used (remove the
inlet if necessary to fit or remove the blocks) if required for additional air cooling;
first freeze them in the freezer for at least 10 hours.
Make sure that the water drain plug (5) is correctly fitted in the bottom of the
-
appliance.
Front grille (7)
-
Filters: inlet pre-filter (8) and filter enclosed (9) in an internal non-woven fabric
-
frame, with openwork slats, sprinkled with water to cool the air passing through it.
22/84