Cleaning And Maintenance - Bimar VR32 Folleto De Instrucciones

•
"SPEED" button: activates the 6 speeds. Each press varies the speed and the
symbol corresponding to the speed selected illuminates: (01-02-03-04-05-06).
•
"TIMER" button: sets the operating time after which the appliance stops. Press the
button in repetition: each press modifies the time (from 0.5 h up to 8h), and the
time selected lights up on the control panel.
(h). To deactivate the timer, press the button until all the times go out (00).
•
"Mode" button: the two modes are selected by pressing the button: Normal and
Sleep. "Sleep" mode reduces the fan speed to the level immediately below the one
set.
Press for about five seconds (a beep is heard) to reset the appliance for wi-fi
connection.
• Weekly programming (only activated via Smartphone): sets: the on/off periods for
each day of the week, normal/sleep mode, 6 fan speeds, right-left swing, Ionizer,
courtesy LED light on/off.
For on-off periods, select the time (hours and minutes) and confirm the function (on
or off), and then the next ones (off or on) - periods may be repeated during the
week; speed, mode, etc. (see details described previously).
USE
Before each use, make sure that:
-the appliance is in good condition
-that the mains cable is not damaged
To operate the appliance insert the plug into the power socket (a "beep" will sound to
indicate that the appliance is in standby mode), press the "ON-OFF" button and start
the function required. To switch off the appliance motor completely, press the "ON-
OFF" button and remove the plug from the power socket.
For long periods out of use, remove the plug from the power socket and empty the
water from the tank.

CLEANING AND MAINTENANCE

Warning: disconnect the plug from the power socket before routine cleaning.
• Filters
These should be cleaned regularly (at least about once a fortnight, or more often if
the appliance is in continual operation every day).
Inlet pre-filter
(8): undo the screw with a screwdriver and use the handle to extract the
filter.
Remove dust with a brush or vacuum cleaner, taking care not to damage any part. If
the filter is very dirty, wash it in warm water and rinse it a few times. The water
temperature must not exceed 40 °C. After washing, leave it to dry fully before
returning it to its proper seat. Never wash in the dishwasher.
Non-woven fabric filter, with openwork slats (9)
vacuum cleaner or a brush, taking care not to damage the surface, and then rinse in
running water. Leave to drain completely.
: remove the frame then clean with a
30/84