Troubleshooting - Blackzon Warrior Manual De Instrucciones

534758
Screw Shaft 3x31mm
534765
Li-ion battey 9.6V 800mAh

TROUBLESHOOTING

Problem
Short run time
Sluggish action
Do not operate
Poor range
The system will not
Connect
The receiver quits responding
During operation
Receiver loses its bind
534759
Screw Shaft 3x36mm
540079
USB Charging Cable
Possible Cause
• Battery damaged/not charged
• Motor dirty or brushes worn
• Motor dirty or brushes worn
• Bind in drivetrain
• Vehicle battery is not charged
• Transmitter batteries low
• Transmitter powered off
• Vehicle battery is not charged
• Low transmitter batteries
• Receiver antenna damaged
• Transmitter and receiver too near each other
• Transmitter and receiver too near large
metal objects (vehicles, etc.)
• Receiver accidentally put in bind mode so
receiver is no longer bound
• Low battery voltage
• Transmitter accidentally put in bind mode,
ending bind to receiver
• Check/change battery
• Check/clean/replace
• Check/clean/replace
• Clean/adjust
• Replace/recharge
• Replace/recharge
• Power On
• Replace/recharge
• Replace/recharge
• Check/repair/replace
• Move transmitter 8–12 feet
(2.4–3.6m) from receiver
• Move away from large metal objects
(vehicles, etc.)
• Rebind transmitter and receiver
• Completely recharge battery
• Bind transmitter to receiver
18 18
534760
390 Motor w/Pinion
534767
2.4G Receiver PCB
Solution