Automatic Functions; Care And Maintenance - Kobra 400 HS Automatic Oiler Instrucciones De Manejo

ENERGY SMART Function: about 12 seconds after shredding
stops, the machine is put in energy saving mode; the
ENERGY SMART Optical Illuminated Indicator (3) switches
off, reducing power consumption to virtually zero.
This function yields an annual energy saving of approximately
10 kW, reducing carbon emissions (the cause of the ozone
hole) by 65 kg.
In order to automatically reactivate all the functions of the
machine, simply insert some sheets of paper or optical
media into the throat (4) or (4a) and engage the photo cells
(5) or (5a). The ENERGY SMART Optical Illuminated Indicator
(3) will then come on to show that the machine has been
reactivated.

AUTOMATIC FUNCTIONS

All Kobra 400 HS Automatic Oiler models come equipped
with the following automatic functions.
• PHOTO CELLS (5) or (5a) to start up the machine
automatically as soon as any sheets of paper or optical
media are inserted into the throat of the machine.
• AUTOMATIC STOP if the bag is full (E) or door is open
(A) signalled by a red light (2) on the control panel.
• MOTOR SAVER which stops the machine working if it
overheats.
(If the motor saver comes on, the machine rests for at
least 10/15 minutes after which time the device restarts
automatically). WARNING. If the motor saver has
kicked in, the machine cannot be activated even if the
Optical Illuminated Indicator (3) is on.
• AUTOMATIC RETURN anti-jam system which, in case of
accidental insertion of a quantity of paper greater than
the maximum capacity of the model, switches off power
to the electric motor and then goes into reverse for a
few seconds in order to unblock the cutting blades,
then stops.
In order to resume shredding, extract the paper from
the throat in order to free the photo cells of paper and
then insert a smaller number of sheets.
• ENERGY SMART SYSTEM which automatically reduces
power consumption to almost nothing when it is in
STAND-BY mode and about 12 seconds after the last
automatic shredding cycle.
• AUTOMATIC OILER, automatic integrated system which
ensures constant lubrication of the cutting blades.

CARE AND MAINTENANCE

Kobra 400 HS Automatic Oiler shredders do not need any
particular care or maintenance.
It is recommended however to periodically check the
amount of oil in the container (P). A flashing red light (2)
signals when oil in the container runs out.
If empty, fill up with oil to ensure efficiency and durability of
the cutting blades.
ACCESSORIES
PRINTOUT SHELF
Only on Kobra 400 HS and Kobra 400HS-COMBI models, it is
possible to have a convenient printout shelf (F) to facilitate
shredding continuous computer printout.
The printout holder is attached to the cover, inserting the
feet of the printout holder into the holes punched into the
cover for this purpose.
AUTOMATIC OILER SYSTEM
REPLACING OIL CONTAINER
Open the lid (A).
Remove the empty oil container (P) from its housing,
unscrew the lid (R) on the top of the container and remove
the oil hose.
Provide yourself with a new oil container, unscrew the seal
and dispose of it, insert the oil hose and tighten the lid (R).
Replace the new oil container (P) in its housing and close the
lid (A). Now your document shredder is ready for use again
with oiled cutting blades.
WARNING !!! The red light (2) might continue to flash during
the first minutes of operation after replacement of the
oil container (P) since the oil supply hose may not yet be
completely full. To speed up the process, engage the photo
cells (5) or (5a) to make the shredder run empty for at least
3/4 minutes.
IMPORTANT: When the red light is flashing, the machine
can still be used normally for shredding any kind of paper
or optical media and no functions are disabled. Over time,
a significant reduction in shredding capacity may however
become apparent.
NEVER use synthetic oil, benzene based products or aerosol
lubricants of any kind inside or near the machine.
Fire hazard.
OIL CONSUMPTION DATA
The oil container which comes with the shredder and the
replacement containers recommended by ELCOMAN, have
a capacity of about 1 litre of oil.
If the shredder is used continuously and without
interruption, the oil
continuous lubrication for approximately 3 hours 30
minutes.
The Automatic Oiler system does not require any
maintenance.
10
container ensures constant