End Of Programming; Decimal Point - Kübler CODIX 541 Instrucciones De Puesta En Servicio

4.5 Dividing factor
It can be set from 00.0001 up
to 99.9999.
The decimal point is set to
4 decimal places. „0" is not
accepted!

4.6 Decimal point

The decimal point defines the
way of displaying the count
values. It does not affect
counting.
0
0.0
0.00
0.000
4.7 SET/RESET Mode
manual reset via the red
SET/RESET key and electri-
cal reset via the SET/RESET
input
no reset (red SET/RESET
key and SET/RESET input
locked)
only electrical reset via the
SET/RESET input
only manual reset via the red
SET/RESET key
4.8 SET value
The device will be set to the
set point by pressing the red
SET/RESET key or activating
the SET/RESET input. SET
value -199 999...999 999
(number of decimal places
depends on the decimal point
option)
For programming the decimal point see 4.6
Page 6
no decimal place
one decimal place
two decimal places
three decimal places

4.9 End of programming

The programming routine is
repeated once more. The
values set until now can be
checked and modified.
The programming routine
wil be left and all values set
will be stored as new pa-
rameters.
Afterwards the device is
ready for operation.
Tachometer/Frequency meter
CODIX 542
(CODIX 544: Operating mode
frequency meter)
1. Description
• 6 digit frequency meter
• Red LED display, character height 14 mm
• Display range from 0 to 999 999
• Leading zeros suppression
• Programming via two setting keys on the
front side
• During programming, the display guides the
user with text prompts
• Value conversion and display in 1/s or 1/min
• With AC power supply: sensor supply
voltage 24 V DC ±15 %/100 mA
• Optional optocoupler output
2. Inputs
INP A
Dynamic count input.
3. Optocoupler output
Active at f=0. Can be used e.g. to activate a
„No operation" lamp.
4. Programming routine
The programmable parameters of the device
are described below, in the order in which they
can be set. The device is fully programmed
after one pass of the routine.
The first values stated correspond
to the factory settings.
(optional)
www.kuebler.com